News

How to install the meat grinder correctly

Update:12-11-2021
Summary:

How to install the meat grinder correctly 1. Install th […]

How to install the meat grinder correctly

1. Install the meat grinder power supply

Before the meat grinder is connected to the power supply, make sure that the power supply voltage is within the normal range. Open the hopper first and take out the spare parts scattered in the hopper mouth. Remove the mouth ring, take out the castor, knife, and twist shaft. After pressing the power supply, face the meat grinder bobbin and press the switch to see if the rotation direction of the output shaft at the bottom of the cylinder is counterclockwise. If it is, the installation is correct. Otherwise, wrong. The power phase sequence should be replaced. The M8 or M6 bolt on the lower back of the machine is an "Equipotential Grounding Terminal" and should be grounded by a professional electrician in accordance with regulations. The grounding hole of the power socket or the green-yellow of the equipment power cord should be firmly grounded. The fixed circuit must be equipped with a cut-off electrode with all poles disconnected and the contact distance ≥ 3mm.

2. Install accessories

When the twisting shaft rotates in the correct direction, install the twisting shaft, knife, grate, and mouth ring in turn. When installing the winch shaft, the long slot at its tail should be installed in conjunction with the long wedge on the output shaft; the knife blade should be installed on the square shaft at the front end of the winch shaft; the grate should also be installed on the front end of the winch shaft. On the square shaft, fit well with the pin at the mouth of the reaming cylinder, and screw on the mouth ring. Tighten the mouth ring and then buckle it back to an appropriate level. Only after the machine is running normally can the meat be minced.

3. Adjust the triangle belt
When the machine is in use, if it is found that the V-belt is too loose or too tight, stop it first. The vertical meat grinder opens the round hole door under the electrical box, loosens the nut and adjusts the position of the motor. After the adjustment is appropriate, lock the nut before it can be used; after the desktop meat grinder opens the chassis, loosen the nut and adjust the bolt Then lock tightly.

0
Views: 519